Manufacturers of Cooling Towers, Systems & Air Strippers by Delta Cooling Towers, Inc.

Principles of Cooling Towers

All cooling towers operate on the principle of removing heat from water by evaporating a small portion of the water that is recirculated through the unit. The heat that is removed is called the latent heat of vaporization. Each one pound of water that is evaporated removes approximately 1,000 BTU’s in the form of latent heat.

COOLING TOWER TERMS AND DEFINITIONS

BTU (British Thermal Unit) A BTU is the heat energy required to raise the temperature of one pound of water one degree Fahrenheit in the range from 32° F to 212° F

Cooling Range The difference in temperature between the hot water entering the tower and the cold water leaving the tower is the cooling range.

Approach The difference between the temperature of the cold water leaving the tower and the wet- bulb temperature of the air is known as the approach. Establishment of the approach fixes the operating temperature of the tower and is a most important parameter in determining both tower size and cost.

Drift The water entrained in the air flow and discharged to the atmosphere. Drift loss does not include water lost by evaporation. Proper tower design can minimize drift loss.

Heat Load The amount of heat to be removed from the circulating water within the tower. Heat load is equal to water circulation rate (gpm) times the cooling range times 500 and is expressed in BTU/hr. Heat load is also an important parameter in determining tower size and cost.

Ton An evaporative cooling ton is 15,000 BTU’s per hour.

Wet-Bulb Temperature The lowest temperature that water theoretically can reach by evaporation. Wet-Bulb temperature is an extremely important parameter in tower selection and design and should be measured by a psychrometer

Pumping Head The pressure required to pump the water from the tower basin, through the entire system and return to the top of the tower.

Makeup The amount of water required to replace normal losses caused by bleed off, drift, and evaporation.

Bleed Off The circulating water in the tower which is discharged to waste to help keep the dissolved solids concentration of the water below a maximum allowable limit. As a result of evaporation, dissolved solids concentration will continually increase unless reduced by bleed off.